I have a 2006 Dodge Ram. I hooked up the evo-all with the t harness and made the 4 connections at the ignition switch, I have triple checked all the connections they are hooked up to the correct wires and have verified that they are getting connection but when I start to program the module I hold down the button while pluging in the data connector and stop on the blue light, I then connect the other connectors but when I do the next step which is turning the key on the blue light goes out, when i turn the key back off the blue light comes back on. I have used the flash link and verified that everything is set up correctly and has the latest firmware. I think this is the step that is supposed to be programming thru the can bus, Any ideas would be very helpful
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
